Bont Size Chart and Fax Instructions

Feet Tracing Instructions

Please trace your foot following exactly the following steps. The fax machine occasionally changes the size of the tracing so we need you to put measurements on it for us as you will see below. Then when the fax arrives, all we need to do is double check the measurement you gave us to make sure it matches.

Instructions:

With both feet traced like this:

• Use a sheet of clean white paper.
• You must be standing with bare feet.
• Trace one foot at a time.
• Pen must be vertical (not at an angle)

• Place your bare foot diagonally on the paper (leave a 1cm boarder).
• Use a black pen, but not thick one.
• Trace all the way around your foot
• Remove the first foot and repeat with the 2^nd foot crossed over the first one on the same paper.
• Trace 2^nd foot.
• Draw a vertical line down the paper.
• It must be at least 10” or 25cm ideally it should be the length of the tracing.
• The reason for the line is so I can check if the fax has changed thetracing.
• I need a small horizontal line at each end of your vertical line so I can clearly see where it starts and finishes.
• Lastly I need you to write the EXACT measurement of the line, on the line.
• Add your name, phone number and email address.
• It should look like this when you are done:

Our fax # is: + 86 591 87 30 80 08.
If that number is busy try our other office number but make sure it says 'Attention Wynne' on it: + 86 591 83 91 18 08

Any questions, just ask.

Australian customers can contact the closest Bont dealer via the link