BUY WITH CONFIDENCE
You can always buy Bont Skates with confidence. Skaters have been buying Bont Skates since 1975 and we are the world’s largest manufacturer of inline speed skates and short track speed skates and custom skates as well as one of the largest manufacturers of roller derby skates.
We have a reputation for looking after our customers. We do everything possible to ensure that our products are made to the highest standards. As an example, all of our boots go through 16 individual stages of quality control before they are shipped out.
Our inline wheels, roller skate wheels and frames are all tested for strength and fatigue on the computer using the most advances computer-aided stress testing available. Bont bearings are produced in partnership with some of the best speciality bearing manufacturers in the world.
All Bont products go through a rigorous team testing phase before being brought to market. Team Bont skaters are the very best in the world.
When you buy Bont Skates, you get the best skates on the market.
The Bont Rip Jaws is a hot spot removal tool Bont invented this tool in 1976 and supplied them to some shops and distributors over the years but this is the first time that we are making the tool available to the public.
This tool is perfect for removing hot spots from the heel of carbon inline skates, ice speed skates, and roller skates. It also works for figure skates and ice hockey skates. You can use this boot stretching tool to stretch your boots wherever you feel pain.
The Bont Rip Jaws hot spot removal tool removes hotspots from your boots. A hot spot is an area of discomfort in your boot. Carbon fiber and fiberglass boots only have a very thin layer of padding between your foot and the hard carbon fiber. Sometimes blisters can occur and the Rip Jaws has been designed to stretch the area of discomfort out to make the boot comfortable to skate in.
1) Remove the laces from your skates
2) Heat the area of discomfort with a hairdryer for about 5 minutes or in the oven. Refer to your boot manufacturer's heat molding instructions. Click here for Bont heat molding.
3) Open the Rip Jaws and use the knob at the end of the handle to open it up widely.
4) Put the Rip Jaws over the problem area and use the same knob to tighten the screw.
5) Pull the handles together so it locks in place.
6) Wait a few minutes for the boot to cool and then unlock the Rip Jaws
You can do this process again if need be.
Remember that if you have a blister or a painful spot on your foot, it's best to let it heal before testing the boot because your foot will still feel painful if it has not healed.